河北铁芯厂

变压器铁芯结构形式的不同，装配方法和工装设备也有很大的不同。平板叠积式和卷铁芯的铁心的装配方法和设备就相差很大。下面叙述普遍采用的平板叠积式铁心的装配方法、工艺和工装设备。

The structure of transformer core is different, and the assembly method and equipment are very different. The assembly method and equipment of the plate superposition and the iron core of the core are quite different. The assembly method, process and equipment of the plate laminated core, which is generally adopted, are described.

①铁芯片号管理和准备，平板叠积式铁芯的芯柱和铁轭，由多种形状和尺寸的硅钢片交换位置叠积而成，最后夹紧成一个整体。

Iron chip number management and preparation, flat laminated iron core column and an iron yoke, made of silicon steel sheets of different shapes and sizes of the exchange position fold up into the clamp as a whole.

②铁芯的叠装工艺，根据平板叠积式铁芯特点，叠板工人在装配铁芯时，一般都是手工操作。

(2) the stacking process of the iron core, according to the characteristic of the plate stacked iron core, the plate worker is usually manual operation when assembling the iron core.

③铁芯叠片滚转架，中小型变压器的铁芯，一般都在固定式台架上进行叠积。铁心叠积工序完成后，用吊钩起立过程中，是在自由状态下翻转90°后再垂直立放的。

3. The iron core stack rolling frame, the iron core of the medium and small transformer, is generally stacked on the fixed platform. After the completion of the iron core stacking process, the hook rises in the process of lifting the hook in a free state and then vertical and then vertical after 90 degrees.