| 非晶合金变压器设计 |
| 添加时间：2019/2/23 16:22:53 浏览次数： |
| 非晶合金铁芯配电变压器的最大优点是，空载损耗值特低。最终能否确保空载损耗值，是整个设计过程中所要考虑的核心问题。当在产品结构布置时，除要考虑非晶合金铁芯本身不受外力的作用外，同时在计算时还须精确合理选取非晶合金的特性参数。除此设计思路外，还须遵循以下三点要求： The biggest advantage of amorphous alloy core distribution transformer is that its no-load loss value is very low. Whether the ultimate no-load loss value can be guaranteed is the core issue to be considered www.buxiugangsanton.cnwww.buxiugangwanto.cnwww.panshiganzaoj.cnwww.ganzaoji.net.cn www.shengwuzhi.net.cnwww.dingjingxiangjiao.cnin the whole design process. When arranging the product structure, we should not only consider that the amorphous alloy core itself is not affected by external force, but also select the characteristic parameters of amorphous alloy accurately and reasonably in the calculation. In addition to this design idea, the following three requirements should be followed: (1)由于非晶合金材料的饱和磁密较低，在产品设计时，额定磁通密度不宜选得太高，通常选取1.3～1.35T磁通密度便可获得较好的空载损耗值。 (1) Because of the low saturation magnetic density of amorphous alloy materials, the rated magnetic flux density should not be too high in product design. Usually 1.3-1.35T magnetic flux density is selected to obtain better no-load loss value. (2)非晶合金材料的单片厚仅为0.03mm，所以其叠片系数也只能达到82%～86%。 (2) The monolithic thickness of amorphous alloy is only 0.03mm, so its lamination coefficient can only reach 82%-86%. (3)为了使用户能获得免维护或少维护的好处，现把非晶合金配电变压器的产品，都设计成全密封式结构。 (3) In order to enable users to obtain the benefits of maintenance-free or less maintenance, the products of amorphous alloy distribution transformers are now designed to be fully sealed. |
| 上一页 变压器为什么用硅钢片做铁芯 |
| 下一页 R型变压器的优势 |
Copyright © 技术支持：遨游网络